Products by:

Float Switch Run Dry Protection

Floating switch (normally open) to switch off the pump at low water (run dry protection). May be installed at the inlet hose or at the submersible pump. The floating switch starts the pump at the minimum level in the cistern. Switch lever and fastening clamp (for hose diameter of 100-140 mm) of stainless-steel. Float housing (red) of polyethylene with flexible switching control 3 x 1 mm² (without intermediate plug)

Water Storage Tanks

The right size for any application. Above ground or below ground, individual tanks as small as 300 Gallons to multi tank or component systems for literally unlimited water storage.

Goulds Submersible Pump

115 volt Cistern pump with 1 1/4" nozzle and base plate, floating filter and suction hose.

Float Switch Water Feed

The floating switch controls the potable water feed. May be installed at the inlet hose or at the submersible pump. Switch lever defines exact switching points so that the water-level rises only about 4 cm (daily demand of a single-family house). Switch lever and fastening clamp (hose diameter 100-140 mm) of stainless-steel. Float housing (yellow) of polyethylene with a flexible switching control 3 x 1 mm² (without intermediate plug).

Floating Coarse Suction Filter

For the extraction of the cleanest pre-filtered rainwater out of cisterns and other vessels. The floating ball is made of ecologically harmless polyethylene, the other components of stainless-steel.

Available for both submersible and suction pumps

Wireless Level Sensor

Wireless sensor that gives remote tank level readings by pressing a button on a desktop unit. Sensor has an operating range of 984 to 1600 feet. The maximum detection depth is 10 feet. Sensor and bench unit operate on four “AA” batteries. Sensor can be mounted within minutes. Can be installed on a slope with its adjustable transponder. Suitable for tanks/cisterns made from plastic, tin, wood, concrete and any other materials

Vortex Fine Filter (WFF150)

For roof areas up to 500 sq. m. Includes housing, extension tube, upper ring, filter insert, lifting handle and housing lid. Connects to standard storm water pipes below ground. A 50 cm extension tube can be used to raise the inspection opening to ground level. Housing of polypropylene (PP), filter insert of stainless-steel, dishwasher safe. Filter mesh (basic version).

Smoothing Inlet Valve

Made of stainless-steel. The smoothing inlet valve re-directs the inflow of water to prevent agitation of sediment at the rainwater inlet into the cistern